Control Panel; Operating Modes; Cool Mode; Heat Mode - Danby DPTA090HEB1WDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Remote control receiver
2. Display Panel: Displays the set temperature.
When in fan mode, displays the ambient
temperature. To change the temperature scale
being displayed, press and hold the up and
down buttons at the same time for three seconds.
3. Fan Button: Used to set the fan speed. The fan
can be set to low, medium, and high. The lights
will indicate the chosen fan speed.
4. Continuous fan button: In cooling mode, press
to set the fan to run continuously.
5. Increase and decrease buttons: Used to adjust
the set temperature in 1° increments.
6. Mode button: Used to choose the operating
mode. The lights will indicate the chosen mode,
cool, heat or fan.
7. Power button: Used to turn the appliance on or
off.
3
4
1
2
5

OPERATING MODES

There are three operating modes to choose from.
Press the Mode Button repeatedly to choose the
desired mode. The adjacent indicator light will
illuminate to show which mode has been selected.

• Cool Mode

Choose cool mode to set the cooling function. Use
the up and down buttons to choose the desired
temperature. When cool mode is selected, the fan
speed can be adjusted by pressing the fan button.

• Heat Mode

Choose heat mode to set the heating function. Use
the up and down buttons to choose the desired
temperature.

• Fan Mode

Choose fan mode to run the internal fan without
engaging the cooling function. Press the fan button
repeatedly to choose the fan speed, low, med or
high.
6
7
8