Publicité
Les langues disponibles
Les langues disponibles
41. Place the aileron servo on the cover and use a felt-tipped
pen to mark the locations for the mounting screws. The servo
output will face forward.
42. Remove the servo and use a pin vise with a 1/16-inch
(1.5mm) drill bit to drill the four servo mounting screws.
43. Thread a servo mounting screw into each hole, then remove
the screws.
44. Apply 2–3 drops of thin CA in each hole to harden the
surrounding wood. Allow the CA to fully cure before
proceeding.
45. Mount the servo using the screws provided with the servo.
Center the servo and attach the servo arm perpendicular to
the servo centerline. Remove any arms that will interfere with
the operation of the servo.
Aermacchi MB-339
46. When connecting the clevis to the servo arm, use the hole
that is 5/8 inch (16mm) from the center of the servo arm.
47. Secure a 12-inch (300mm) servo extension to the servo lead
using a Servo Connector Clip (SPMA3054).
48. Tie the string inside the wing to the end of the extension.
49. Remove the cover for the flap servo. Use the string to pull the
extension to the opening for the flap servo.
50. Use a toothpick or hobby knife with a #11 blade to puncture
the aileron servo cover for the mounting screws.
9
5/8 inch
(16mm)
EN
Publicité
