Horizon Hobby Hangar 9 Aermacchi MB-339 Manuel D'utilisation page 8

AILERON HINGING
31. Hinge the ailerons using the same technique outlined for the
flap hinges. Make sure the aileron is aligned with the flap.
32. Make sure hinge gap is consistent along the entire length of
the aileron. Use low-tack tape to hold the aileron in position
until the adhesive has fully cured.
Î Trial fitting the tip tank at this stage allows for the
installation of the aileron and verification the aileron
will not come in contact with the tip tank..
ELEVATOR HINGING
33. Separate the elevator from the stabilizer. Set the hinges aside.
34. Install the control horn for the elevator using the techniques
used for the aileron control horn.
35. Use the same technique as the flap hinges to secure the
elevator hinges. Make sure to remove any excess adhesive
from the hinges using a paper towel and isopropyl alcohol.
Use low-tack tape to hold the elevator in position until the
adhesive has fully cured.
EN
RUDDER HINGING
36. Separate the rudder from the fin. Set the hinges aside.
37. Install the control horn for the rudder using the techniques
used for the aileron control horn.
38. When installing the rudder hinges, note that the bottom hinge
has been shortened to fit into the fin.
39. Use the same technique as the flap hinges to secure the
rudder hinges. Make sure to remove any excess adhesive
from the hinges using a paper towel and isopropyl alcohol.
Use low-tack tape to hold the rudder in position until the
adhesive has fully cured.
AILERON SERVO INSTALLATION
40. Remove the covering for the servo arm in the aileron servo
cover using a hobby knife and #11 blade. Make sure the hole
in the cover is aligned with the aileron control horn before
proceeding.
8