Publicité
Les langues disponibles
Les langues disponibles
en-us Installation Procedure
Remove the hose clip from the back of the dishwasher.
3.
It can be used later to hold the drain hose inside your
cabinet.
4 Installation Procedure
Installation Procedure
Follow these instructions to install the dishwasher.
Installation Procedure
4.1 Pre-level the Dishwasher
Set the dishwasher to the correct height before it goes into
the cabinet.
Measure the height of the cabinet opening.
1.
Raise the front of the dishwasher to approximately 1/2"
2.
lower than the height of the opening by turning the feet
clockwise.
You can raise the rear foot after the unit is in the cabinet
opening.
8
Use a level on the top front to see that both feet are
3.
even.
4.2 Attach Power Cord
Plug the end of the supply cord into the back of the
▶
dishwasher.
Be sure to push it all the way in until fully seated.
‒
The outlet for the power supply cord should be located
in a cabinet or wall adjacent to the dishwasher cabinet.
Do not plug dishwasher into the wall outlet until all the
steps of the installation are complete.
Notes
If you require a permanent wiring connection, order kit
¡
junction box accessory kit SMZPCJB1UC.
If local electrical codes require clips to secure the power
¡
cord wire to the dishwasher, use accessory kit
SMZEPCC1UC.
4.3 Mounting Brackets
Before installing the supplied mounting brackets, decide
which method of securing the dishwasher into its
enclosure will be used, top (wood or porous material) or
side (stone or solid surface). Once the mounting brackets
are installed on the dishwasher, removing them is difficult
and will damage the mounting brackets and the
Publicité
