Bosch HDIP056U Manuel D'utilisation page 34

en-us Cleaning and maintenance
Self clean function
With pyrolytic self cleaning the oven is heated to a very
high temperature. Stubborn soil is burnt off and can be
wiped out after self clean is finished and the oven has
cooled.
After the completion of a self-clean cycle, the oven will not
allow you to start another self-clean cycle for 24 hours.
All surface elements are automatically disabled during Self
Clean. This is normal. Once the Self Clean cycle is
complete and the oven has cooled, the elements become
operable once again.
WARNING
To avoid risk of personal injury, while the Self Clean cycle
is operating, do not operate the cooktop and ensure that
all surface controls are turned off.
Preparing self clean
WARNING
During the elimination of soil during self-cleaning, small
amounts of carbon monoxide can be created and the
fiberglass insulation could give off very small amounts of
formaldehyde during the first several cleaning cycles.
To minimize exposure to these substances, provide
▶
good ventilation with an open window, or use a
ventilation fan or hood.
During the self clean cycle, parts of the appliance may
become potentially harmful to persons who lack adult
knowledge of appliances and adult reactions to potentially
harmful conditions.
Children should not be left alone or unattended in an
▶
area where appliances are in use.
The oven heats up to a very high temperature during self
cleaning. Opening the door can result in injury.
When self-cleaning, confirm that the door locks and will
▶
not open.
If the door does not lock, do not run Self Clean. Contact
▶
Customer Service.
CAUTION
Remove broiler pans, pots, and other utensils and excess
spillage before self-cleaning.
Do not leave food or cooking utensils, etc., in the oven
during the pyrolytic self-cleaning mode of operation.
CAUTION
The oven vents are important for air circulation. Covering
the oven vents will cause the oven to overheat. Refer to
the appliance overview for the location of the oven vents.
→ "Appliance", Page 14
Do not obstruct oven vents.
▶
NOTICE:
Do not clean parts or accessories with the self clean
function.
Wipe out excessive spillage from the oven cavity.
▶
34
Starting self clean
Requirements
¡ All heating modes or timers are canceled.
¡ You have carried out the steps for preparing the oven
for self clean.
→ "Preparing self clean", Page 34
Press Self Clean.
1.
lights up on the display.
a
a The default self clean time "4:00" blinks on the timer
display.
You can set a self clean time between 2 and 4 hours
2.
with the numeric keypad.
Tip: Use a longer setting for a heavily soiled oven.
Press Enter.
3.
a The oven door locks.
remains lit until the oven has cooled down after self
clean is finished.
a "SELF CLEAN" lights up on the display.
a The timer starts to count down.
a When self clean is finished, the display shows 0:00. The
oven remains locked until it has cooled down
sufficiently. "COOLING DOWN" is displayed.
a When the oven has cooled down the door unlocks and
"SELF CLEAN FINISHED" is displayed.
Press Oven Clear/Off.
4.
Wipe the remaining ash from the oven with a moist
5.
cloth.
Canceling self clean
Press Oven Clear/Off.
1.
a "COOLING DOWN" is displayed.
a The door remains locked.
a When the oven has cooled down the door unlocks and
"SELF CLEAN FINISHED" is displayed.
Press Oven Clear/Off.
2.
Wipe the remaining ash from the oven with a moist
3.
cloth.
Maintenance
Replacing an oven light bulb
When the oven light fails you can replace the light bulbs.
WARNING
Light socket is live when door is open if main power supply
is not turned off.
Turn off main power supply at the service panel before
▶
changing the light bulbs.
WARNING
Make sure the appliance and lights are cool and power to
the appliance has been turned off before replacing the
light bulb(s). Failure to do so could result in electrical
shock or burns.
The lenses must be in place when using the appliance.
▶
The lenses serve to protect the light bulb from breaking.
▶
blinks on the display and then