Publicité
Les langues disponibles
Les langues disponibles
Instructions for installation and use
2.2. Safety information for the installer
● Installing and connecting the sauna heater may only be performed
when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
● Always use silicone cables that are heat-resistant up to 150 °C
to connect the heater.
● Only install one sauna heater in the cabin. The Concept R combi
sauna heater must not be used together with other sauna heat-
ers in a sauna cabin.
● The roof and walls of the sauna cabin are manufactured from
low-resin, untreated or thermally treated woods, e.g. Nordic
spruce, hemlock, pine or fir, or from laminated wooden materi-
als. If laminated wooden materials are used, make sure that the
adhesive does not produce formaldehyde. If other materials apart
from wood are used in the sauna cabin, these materials must
be heat and corrosion-resistant and must not have any negative
effects on the health of the sauna users.
● The height of the sauna cabin must be at least 2.0 m.
● Observe the specifications on volumes and on ventilation of the
sauna cabin in chapter 10. Technical data on page 26.
● When positioning the sauna heater, observe the minimum safety
distances (see chapter 4.2. Safety distances on page
● Also comply with the regulations applicable in the installation
location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
WORLD OF WELLNESS
p. 7/26
EN
).
12
Publicité
