Maytag Performance Serie Guide D'utilisation Et D'entretien page 32

Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Is the Sensor cycle ending early?
The load may not be contacting the sensor strips. I.evel the dryer.
Change the dryness [eve[ setting on Sensor Cycles. Increasing or decreasing the dryness
[eve[ will change the amount of drying time in a cycle.
Lint on load
• Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
• Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
I)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
Select the Custom Refresh Cycle to tumble the load with water and heat to help smooth
out wrinkles from a load [eft in the dryer.
Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
Have you recently been painting, staining or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
• Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor will be gone after the first
cycle.
32