Citizen JDVD3825PB Manuel D'instructions page 10

Basic connections
Antenna to DVD/VCR connection
The DVD/VCR must be connected "between" the antenna and
the TV. First, disconnect the antenna from the TV and connect
it to the DVD/VCR. Then connect the DVD/VCR to the TV.
Below are 3 common methods of connecting an antenna sys-
tem to a DVD/VCR. Find the type of antenna system you are
using and follow the connection diagram.
Example 1: Combination VHF/UHF antenna with 75 ohm
coaxial cable
75 ohm coaxial
cable
Example 2: Combination VHF/UHF antenna with 300 ohm
twin lead (flat) wire
300 ohm twin lead
(flat) wire
Example 3: Separate VHF and UHF antennas
VHF UHF
300 ohm twin
lead (flat) wire
75 ohm coaxial
cable
NOTE:
If both VHF and UHF antennas have 300 ohm twin lead (flat)
wires, use a combiner having two 300 ohm inputs and one 75
ohm output.
NOTES:
• A clear picture will not be obtained by the main unit unless
the antenna signal is good. Connect the antenna to the
main unit properly.
• For better quality recording, an indoor antenna or a
telescopic antenna is not recommended. The use of an
outdoor type antenna is required.
• If you are not sure about the connection, please refer to
qualified service personnel.
10
IN
(ANT)
OUT
(TV)
DVD/VCR
Matching transformer
300 ohm input 75 ohm
output (not supplied)
IN
(ANT)
OUT
(TV)
DVD/VCR
Combiner
75/300 ohm inputs
75 ohm output (not supplied)
IN
(ANT)
OUT
(TV)
DVD/VCR
DVD/VCR to TV connection
After you have connected the antenna to the DVD/VCR, you
must connect the DVD/VCR to the TV.
Below are 3 common methods of connecting your DVD/VCR
to a TV. Find the type of TV you are using and follow the con-
nection diagram.
This DVD/VCR has a single 75 ohm output for connection to a
TV. If your TV has separate VHF and UHF antenna inputs (num-
bers 2 and 3 below), use a splitter to connect the DVD/VCR to
the TV for VHF and UHF reception.
Example 1: TV with single 75 ohm VHF/UHF antenna
input
IN
(ANT)
OUT
(TV)
DVD/VCR
Example 2: TV with 300 ohm UHF and 75 ohm VHF
antenna inputs
75 ohm coaxial cable
(supplied)
IN
(ANT)
OUT
(TV)
DVD/VCR
Example 3: TV with 300 ohm UHF and 300 ohm VHF
antenna inputs
75 ohm coaxial cable
(supplied)
IN
(ANT)
OUT
(TV)
DVD/VCR
NOTE:
If a VHF or UHF antenna is used, set the TV/CABLE menu
option to the "TV" mode.
TV
75 ohm coaxial
cable (supplied)
VHF/UHF
IN (ANT)
TV
UHF
VHF
Splitter 75 ohm input
75/300 ohm outputs
(not supplied)
TV
UHF
VHF
Splitter 75 ohm input
300 ohm output
(not supplied)