REBER SRB3 Manuel D'utilisation Et D'entretien page 25

eliminate all working residue, you are advised to operate the meat mincer
with waste meat for 5 minutes. Screw in the ring nut without forcing it and
strictly avoid unscrewing it when working. At the end of the work, to
dismantle the meat mincer turn the ring nut (11) in an anti-clockwise
direction, remove the knife (10), the plate (9) and the propeller (8), remove
the body in cast iron (7) from the cover of the reducer (6); wash, dry
carefully and, if necessary, grease all the parts that come in contact with
the meat with oil for foodstuff contact. REBER electric meat mincers are
prepared to work with plates having holes in diameter from mm. 3 to mm.
12. REBER srl cannot be held in any way liable for damage and accidents
due to use of plates with holes in diameter over 12 mm.
CHEESEGRATER ACCESSORY ART. 8910 N
Body and handle in aluminum, roll in tin plated steel and collecting box in
plastic for contact with foodstuffs; the optional grater is connected on the
gearmotor unit using a multiplier with geared axial rotations in nylon
supplied in the box.
Legend
1- Multiplier cover 2- Large gear
3- Small gear multiplier 4- Grater pin
5- Multiplier flange 6- Grater blind nut
7- Grater handle 8- Grater body 9- Toothed roll
10- Nylon covers 11- Nylon cover screw
12- Collecting box