Nuna pipa next Mode D'emploi page 15

Check to make sure the base is securely installed by pulling on both ISOFIX
connectors.
5
- After placing the base on the vehicle seat, extend the load leg to the floor
(11). When the load leg is installed correctly, the load leg indicator will show
green. Red will be shown when installed incorrectly. (11)-2
The load leg has multiple positions. When the load leg indicator shows red
this means the load leg is in the wrong position.
Make sure the load leg is in full contact with the vehicle floor pan.
Squeeze the load leg adjustment button, then shorten the load leg upwards.
(11)-1
The completely assembled base is shown as (12).
The ISOFIX connectors must be attached and locked onto the ISOFIX
anchor bars. (12)-1
The load leg must be installed correctly with green indicator. (12)-2
Attaching Infant Carrier to the Base
1
- Push the enhanced child restraint down onto the base (13), If the enhanced
child restraint is secure, the enhanced child restraint indicator will show
green. (14)
Check that the infant carrier is locked onto the base by pulling up on the
handle.
2
- Press the ISOFIX adjustment button and push the base back until it makes
contact with the vehicle seat back. (15)
3
- Press and hold the rotation button to rotate for easier side loading/
unloading of the child. (16)
4
- To release the infant carrier, squeeze the infant carrier release button (17)-1,
then lift the infant carrier up. (17)-2
Uninstalling the Base
1
- To detach the base, start by pressing the secondary lock button (18)-1,
then proceed to the release button (18)-2 on the ISOFIX connectors before
removing the base from the vehicle seat (18).
2
- For transporting, press ISOFIX Adjustment button and move the ISOFIX
connectors back into the storage position. (19)
11
PIPA next instructions
Height Adjustment
for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper height. Please choose
the proper pair of shoulder harness slots according to the child's height.
Shoulder Harness Straps must be nearest to your childs shoulders (20), but
not above the shoulder line. (21)
If the Shoulder Harness Straps are not at proper height, the child might be
ejected from the enhanced child restraint if there is a crash.
Pull the head support adjustment lever (22), meanwhile pull up or push down
the head support until it snaps into one of the 7 positions. The head support
positions are shown as (23).
Securing Child
Use Infant Insert
We recommend using the full
infant insert while the baby
is under 60 cm or until they
outgrow the infant insert. The
infant insert increases side
impact protection.
After the child is placed into the seat, check whether the Shoulder Harness
Straps are at proper height.
1
- While pressing the harness adjustment button, pull completely the two
Shoulder Harness Straps of the enhanced child restraint. (24)
2
- Unlock the buckle of the harnesses by pressing the red button. (25)
3
- Place the child into the infant carrier module and lock the buckle. (27)
Please refer to (26).
4
- Tighten the shoulder harness straps by pulling the adjustment webbing.
(28)
Make sure the space between the child and the Shoulder Harness Straps is
about the thickness of one hand.
Remove the infant
insert when the infant's
shoulders no longer fit
comfortably.
12
PIPA next instructions