Nuna pipa next Mode D'emploi page 14

Parts List
Make sure all parts are available before assembly. The infant carrier module and
base can be sold separately. If any part is missing, please contact local retailer.
No tools are required for assembly.
1 Head support
2 Seat Pad
3 Shoulder Harness Straps
4
Instruction Manual Storage
Compartment (between seat pad
and plastic)
5 Infant Insert
6 Harness Adjustment Button
7 Adjustment Webbing
8 Safety Buckle
1
2
3
4
5
6
7
9
PIPA next instructions
9 Side Guides
10 Stroller Release Button A
11 Canopy Mount
12 Canopy
13 Handle
14 Handle Button
15 Rear Guide
16 Stroller Release Button B
12
11
10
9
8
13
14
Product Use
Installation Concerns
This infant carrier module is suitable for vehicle seats with i-Size ISOFIX anchor
points with the Base. (1)
DO NOT use the rearward facing enhanced child restraint systems in seating
positions where there is an active frontal airbag installed. Death or serious injury
may occur. (2) Please reference vehicle owner's manual for more information.
DO NOT install this enhanced child restraint on vehicle seats that face sideways
or rearward with respect to the moving direction of the vehicle. (3)
It is recommended to install this enhanced child restraint on the rear vehicle
seat. (4)
DO NOT install this enhanced child restraint on vehicle seats movable during
installation.
Handle Adjustment
1
- The handle of the infant carrier module can be adjusted to 3 positions. (5)
2
- To adjust the handle, squeeze handle buttons on both sides to release it.
(6)-1
3
- Rotate handle until it clicks into any of the 3 positions. (6)-2
Installation with Base
1
- Attach the ISOFIX guides to the vehicle's ISOFIX anchor bars (see vehicle
owner's manual). (7) The ISOFIX guides can protect the surface of the
vehicle seat from being torn. They can also guide the ISOFIX connectors.
2
- Unfold the load leg from storage compartment. (8)
3
- Extend the ISOFIX connectors by pressing the ISOFIX adjustment button
while pulling on the connector. (9)
4
- Press the ISOFIX adjustment button to adjust the ISOFIX connectors.
Line up the ISOFIX connectors with the ISOFIX guides, and then "click" both
ISOFIX connectors into the ISOFIX anchor bars. (10)
Make sure that both ISOFIX connectors are securely attached to the ISOFIX
16
anchor bars. There should be two audible clicks and the colors of the
15
indicators on both ISOFIX connectors should be completely green. (10)-1
10
PIPA next instructions