Publicité
Les langues disponibles
Les langues disponibles
Do not remove the foam with a spoon or other metal object. This will damage the coating.
After having used the frother, clean the appliance as described in the chapter Cleaning & Maintenance.
Warning: Allow the appliance to cool down for 3 minutes before using it again.
The milk frother has a built-in protection that is activated after 5 minutes of continuous use. Once the protection has been
activated, the indicator leds start to flash. The appliance must cool down. Wait 5 minutes before switching on the milk
frother again.
TIPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good - less than 75 ml.
• The quality of the milk foam can vary between different brands of milk. If necessary, experiment with other brands of milk
for a better result.
5
heating milk
Lift the lid and fit the mixer in the jug. Fill the desired amount of milk into the jug. Do not exceed the maximum of the top
max. mark - MAX
- 300 ml.
Put the lid back on the jug and place the appliance on the base. Start the preparation by pushing the start button
control light will burn and the mixer will start turning. Depending on the filling volume, the preparation stops automatically
after 90 to 120 seconds. The control light goes out.
After the preparation is completed, remove the lid upwards and pour the hot milk into a cup.After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Warning: Allow the appliance to cool down for 3 minutes before using it again.
The milk frother has a built-in protection that is activated after 5 minutes of continuous use. Once the protection has been
activated, the indicator leds start to flash. The appliance must cool down. Wait 5 minutes before switching on the milk
frother again.
6
cleaning & maintenance
Before cleaning always unplug the appliance and let it cool down completely.
Clean the appliance immediately after every use.
Never use any aggressive or abrasives cleaning agents or sharp objects that could damage the coating!
Never immerse the appliance, the power base, the power cord or plug in water or other liquids.
Remove the whisk or the mixer by pulling it straight upwards.
Rinse the inside of the milk frother with hot water.
In case of stubborn contamination inside, use a drop of dishwashing soap and rinse well. Caution: do not rinse the milk
frother under the tap. As a result, water could reach the electrical part and cause the milk frother to become defective.
Dry with a soft cloth. Make sure you remove all the milk residue from the inside. It is not hygienic and can be harmful.
Clean the lid, the whisk and the mixer with warm soapy water. Dry the parts thoroughly.
Wipe the outside of the appliance with a damp cloth regularly.
. The
13
English
•
Publicité
