INSTALLATION INSTRUCTIONS
UNPACKING AND EXAMINING YOUR MICROWAVE OVEN
Remove all packing materials from inside the microwave oven
cavity; however, DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the top cavity wall. Read enclosures and
SAVE this Installation/Use and Care Guide.
Check the microwave oven for any damage, such as misaligned
or bent door, damaged door seals and sealing surfaces, broken
or loose door hinges and latches and dents inside the cavity or
on the door. If there is any damage, do not operate the
microwave oven and contact your dealer or DCS AUTHORIZED
SERVICER.
CHOOSING A LOCATION FOR YOUR MICROWAVE OVEN
You will use your oven frequently so plan its
location for ease of use. Allow at least 2 inches on
the sides, top and at the rear of the oven for air
circulation.
Your oven can be built into a cabinet or wall by
itself or above any DCS wall oven using DCS's Built-
in Trim Kit listed below. It cannot be built in above
conventional gas or electric ranges or any other
2" min
wall ovens.
DCS Built-in Trim Kit: CMOSTK27, CMOSTK30
DCS Wall Ovens: WO-127, WO-130, WOS-127,
WOS-130
36" min
Electric Wall Oven
6