Bosch TWK7601 Mode D'emploi page 10

en
Congratulations on purchasing this
Bosch appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid
3 Lid opening button
4 On/Off switch, illuminated
5 Limescale filter (removable)
6 Base
7 Cable tidy
Important: Use the kettle only with its
included base.
■ Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
without water and do not overfill it;
observe the min and max markings. If
the kettle is too full, the water will boil
over!
Before using
for the first time
■ Remove any stickers or film.
■ Unroll the right amount of cable from the
cable tidy and plug it in.
■ Fill the kettle with water. Bring the water
to a boil and discard it. Repeat the
procedure. This will make sure that the
kettle is clean for normal use.
■ When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Boiling water
■ Fill the kettle with fresh water, either
through the spout or by pressing the
opening button to open the lid.
■ Read the quantity on the water level
indicator. Do not fill with less than
0.3 litres or more than 1.7 litres of water!
■ Close the lid.
8
■ Press down the switch; the switch lights
up. The water is heated.
■ The kettle switches off automatically
once the water has boiled.
The appliance can also be switched off at
any time by pulling up the switch.
Warning: If you remove the kettle from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.: Only operate the kettle with the lid
closed and the limescale filter inserted,
otherwise the kettle will not switch off.
For physical reasons, the base may collect
some condensation water. This is normal; it
does not mean that the kettle leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle is
empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.
Cleaning and maintenance
W Risk of electric shock!
Never immerse the device in water or place
it in the dishwasher!
Do not steam­clean the appliance.
■ Before cleaning, unplug the appliance
from the power outlet.
■ Clean the outside of the kettle and
base with a damp cloth. Do not use
strong or abrasive cleaning agents.
■ Remove the limescale filter, soak it in a
little vinegar, then rinse clean with clear
water.
■ Rinse the kettle and the limescale
filter with clear water.