Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
GUIDE
D
Components of tension system
Run 4 times
3
DELTA PLUS GROUP
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE
www.deltaplus.eu
AN801TEN/ ASSEMBLY
P6 : Insert positioning pin
1 x T
: Spring tension
2 x N1 : Nut M12
1 x A1 : Anchorage screw M12
1 x W2 : Bolt D12
2 x V : Calmp cable
1 x R : Thimble sleeve loop
Installation of tension system
AN801-AN802- ASSEMBLY GUIDES - (EN) -
Tools for installation
- All tightening of bolt should be realized with the torque wrench to
1 x wrench size 13
make sure of the value of tighten.
1 x wrench size 17
- Loctique glue for screw can also be use on the nuts.
2 x wrench size 19
- Proceed to the positionning of the tension system AN801TEN on
1 x pincer
the low anchorage AN801UNI allready fixed.
1 x piece of tape
- the plate of positionning P6 of the pin tension for spring T must be
fixed on the low anchorage AN801UNI with tightening of bolt M16.
1 x Torque Wrench size 17 for
check of the torque value
Screws of the clamp cable on the
side of active cable
30 daN
Recommandation
UPDATE : 04 03 2020
Publicité
