Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
user's instructions
oPerAtion - General
The appliance is intended only for domestic use,
not for professional use.
1. Mounting plate
2. Canopy
3. Down rod
4. Motor
5. Fan blades (4x)
6. Fan blade holder (4x)
7. Screws mounting plate (2x)
8. Screw set fan blades (12x)
9. Balance weight (2x)
10. Balance clamp
11. Glass lamp cover
MontAGe - installing the mouting plate
•
ALWAYS SWITCH OFF THE MAINS POWER BEFORE INSTALLING OR CARYING OUT ANY
WORK ON THE CEILING FAN.
•
Be sure to hang the fan in a place where the distance between the fan blades and the floor will be at
least 2.30m.
1
2
A
1. In the packaging the mounting plate is already assembled to the canopy by four screws (see figure A).
2. Loosen the two screws
3. Unscrew the two screws
d
4. Remove the mounting plate from the canopy and unscrew the yellow-green earth wire from the canopy (D).
5. Lead the wires emerging from your ceiling through the opening in the mounting plate (E).
6. Screw the mounting plate to the ceiling (F). Make sure the mounting plate is mounted firmly enough to
hold a minimum weight of 23 kg (51 lb).
2
1
B
halfway (B).
1
completely and remove them (C).
2
e
1
2
5
7
10
9
8
1
f
35
3
4
6
11
2
c
G
Publicité
Table des Matières
