Zipper Maschinen ZI-EWB350 Mode D'emploi page 22

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
9. Step
Assemble the brackets (1) to the rear of the
battery box system using screws with serrated
flange screws (2).
Then fix the battery box system (3) and the
protector plate (4) to the bore holes (5).
For each borehole (5), a screw (6), spring
washer (7), washers (8) and a nut (9) are
required.
10. Step
Insert the plug of the motor control unit (1)
into the socket on the underside of the battery
box and secure it with the lock nut.
11. Step
Insert the plugs of the drive unit (1, 2) into the
respective matching socket on the underside
of the battery box and secure with lock nuts.
12. Step
Fix the cable of the drive unit on two positons
to the basic frame using a clamp (1), bracket
(3), screws (2), washers (4) and nuts (5).
13. Step
Secure the orange cable of the drive unit to
the protector plate with a cable tie (1) and to
the cross strut with a Velcro strap (2).
Secure the cable of the motor control unit
with a Velcro strap (3).
Secure the brake cable with a cable tie (4).
ASSEMBLY
22
ZI-EWB350