Zipper Maschinen ZI-EWB350 Mode D'emploi page 21

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
4. Step
Assembly unlock tilt function:
Remove the unlock knob (1) and the nut (2).
Insert the wire into the bracket (nut 3 below
the bracket).
Fasten the nut (2) and the unlock knob (3).
5. Step
Hook the brake cable (2) onto the brake lever
(1).
The brake lever can then be fixed in position
with screw (3).
Make the connection to the brake on both
wheels:
To do this, mount the bolt (4) on the right and
left brake linkage (6) in the device as shown
and secure using a split pin and washer (5).
6. Step
Install fixing screws
compression spring (2) and a washer (3), at six
positions onto the tubular frame.
7. Step
Slide the frame left (1), right (2) and front (3)
into the tubular frame and fix in the desired
position with fixing screws.
8. Step
Position the tubular frame on the basic frame.
The boreholes (1) must be positioned one
above the other.
Secure the tubular frame to each borehole
with a screw (2), washers (3), spring washer (4)
and a nut (5).
ASSEMBLY
(1), each with a
21
ZI-EWB350