Aqua Medic PERCULA 100 T5 Mode D'emploi page 24

5.3. Technical data, table 1
Type:
Pump voltage:
Power uptake, watts:
Voltage transformer:
Max. l/h:
Min. l/h:
Cable length in m: Pump:
Transformer:
Class/protection rating:
Max depth:
Max. media temperature:
Adjustment at the transformer:
The flow rate can be adjusted at the transformer to the level 6 / 9 / 12 V. When operating at 6 V,
we recommend firstly to select 9 or 12 V and then re-set to 6 V.
The pump is open at the front. Therefore, it should never be started uncontrolled, e. g.
via a time switch. Animals could be in the sucking in basket and they could be injured or killed by
the starting propeller.
5.4. Exploded parts diagram
Fig. 5: Structure NanoProp 5000
1. Filter basket
2. Rotor assembly
3. Motor housing
5.5. Set Up
The pump can only be operated under water. The maximum depth is 1 m. The pump should be
mounted at least 10 cm below the water surface to avoid air to be sucked in. The pump is a pure
current pump. No piping or hoses may be attached to it in order to lift water up.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on
the aquarium or pump, the power plug must be disconnected from the mains.
The connection cable and power plug must not be changed. If the power cable is
damaged, the pump must be scrapped.
24
NanoProp 5000
6 – 12 V DC
4 – 7 watts
100 – 240 V, 50 – 60 Hz
5,000
2,000
2,8
1,50
1/ IP 68
1 m
∇
1m
35° C