Briggs & Stratton WP2-55 Manuel D'utilisation page 19

page de 153

/ 153
Signets

Les langues disponibles

Product Specifications

Model 073009, 073010, 073029

Water Pump Specifications

Suction Port Diameter . . . . . . . . . . . . . . . . . . . . . . 5 cm (2 in)

Discharge Port Diameter . . . . . . . . . . . . . . . . . . . . 5 cm (2 in)

Total Head. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32 m (106 ft)

Maximum Head

Suction Lift. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 m (26 ft)

Discharge Lift . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 m (82 ft)

Maximum Discharge Capacity. . . 600 l/min (159 US gal/min)

Engine Specifications

Displacement . . . . . . . . . . . . . . . . . . . . . . . 206 cc (12.48 in 3 )

Oil Capacity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.59 l (20 oz)

Tune-up Specifications *

Spark Plug Gap. . . . . . . . . . . . . . . . . . . . . 0.76 mm (0.030 in)

Spark Plug Torque . . . . . . . . . . . . . . . . . . . .20 Nm (180 lb-in)

Common Service Parts **

Air Filter .....................................................................696263

Fuel Additive ........................................................5041, 5058

Resistor Spark Plug ...................................................797235

Engine Oil Bottle ...................................... 100005 or 100028

Fuel Stabilizer .............................................. 100002 or 5041

** We recommend that you see any Briggs & Stratton Authorized

Dealer for all maintenance and service of the water pump. Use

only genuine Briggs & Stratton parts.

Power ratings: The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers)

code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in accordance with

SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine

power will be lower and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide

array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine

will not develop the rated gross power when used in a given piece of power equipment (actual "on-site" or net power). This difference is due

to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application

limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity

limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

Tested in accordance with CPB standards for self-priming centrifugal pumps with clear water at sea level.

water Pump

Product Specifications

Model 073011, 073012, 073030

Water Pump Specifications

Suction Port Diameter . . . . . . . . . . . . . . . . . . . . . 7.6 cm (3 in)

Discharge Port Diameter . . . . . . . . . . . . . . . . . . . 7.6 cm (3 in)

Total Head. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32 m (106 ft)

Maximum Head

Suction Lift. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 m (25 ft)

Discharge Lift . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 m (81 ft)

Maximum Discharge Capacity. . . 939 l/min (248 US gal/min)