Bosch NGMP659UC Manuel D'utilisation page 11

4.2 Control knobs
You can use the control panel to configure all functions of
your appliance and to obtain information about the
operating status.
The markings around the control knobs show the available
power levels. There are 9 power levels. When you turn on
the burner, the display next to the control knob shows the
power level.
Note: The image of the control knob is representative.
Depending on the available settings, the individual control
knobs may have some but not all functions described in
the following chart.
Knob position
off Burner turned off
Electronic ignition
Power levels
hi Highest power level
lo Lowest power level
sim Simmer setting
Burner positions
The markings next to each of the control knobs show
which burner they control.
Burner
positions
Front left burner
Front right burner
Middle burner
Back left burner
Back right burner
Displays
Each burner has a display that shows the current state of
the burner.
Display
Burner off
Electronic ignition
Familiarizing yourself with your appliance en-us
Display
- Power levels
⁠ / Residual heat indicator
Dual flame burner control
For dual-flame burners, the inner and outer flames can be
controlled separately.
Power level
4.3 Burner cap and burner base placement
The burner caps must be properly placed for the cooktop
to function properly.
If the burner cap is not properly placed, one or more of the
following may occur:
¡ Burner flames are too high
¡ Flames shoot out of the burners
¡ Stainless steel discolorations
¡ Burners do not ignite
¡ Burner flames light unevenly
¡ Burner emits gas odor
WARNING
To prevent flare-ups do not use the cooktop without all
burner caps and all burner grates properly positioned.
CAUTION
To prevent burns, do not touch burner caps or grates while
hot.
Turn the cooktop off and allow the burners to cool.
▶
Meaning
Inner and outer flame on
full power
Outer flame on low power,
inner flame on full power
Inner flame on full power
Inner flame on low power
11