Urmet 1043 Guide Rapide D'utilisation page 17

TECHNICAL SPECIFICATIONS
Mains power supply:....................................................................................................100-240V~ - -15/+10% - 50/60Hz - 3A
Operating temperature: ................................................................................................................................-5°C ÷ +40°C
Maximum non-condensing operating relative humidity:........................................................................................93% +2/-3%
Degree of protection of the metal/plastic casing:....................................................................................................................IP30
(*) = Power supply: CAT III 4000 V
Use cables that comply with local, national, European and international safety regulations.
The cables used must comply with IEC 60332-1-2 if they have a cross-section of 0.5 mm
a cross-section of less than 0.5 mm
KEY TO SYMBOLS
Symbol
⎓
Direct current voltage.
~
Alternating input voltage.
The lightening symbol in a equilateral triangle indicates the presence of dangerous voltage. Do not open
the device.
See the installation manual of the device.
DS1043-271A
Via Bologna, 188/C - 10154 Torino - Italy
DoP 1043/570A
Control and indicating equipment for fire
detection and fire alarm system for buildings
EN 54-2: 1997 + A1:2006
EN 54-4: 1997 + A1:2002 + A2:2006
100-240 V -15/+10%, 50/60 Hz, 3 A
Vout: 26 V⎓, ± 10%, 4.85 A
Circuit modules: 4 up to 12
Options with requirements list:
7.8 Output to fire alarm device
7.9 Output to fire alarm routing equipment
7.11 Delay to outputs
7.12 Co-incidence detection
8.3 Fault signals from points
8.9 Output to fault warning routing equipment
9.5 Disablement of addressable points
10 Test condition
2
.
17
22
0051
22
2
or more, or with IEC 60332-2-2 if they have
Meaning
LBT21120