Urmet 1043 Guide Rapide D'utilisation page 10

ENGLISH
PREFACE
This booklet provides the minimum information required to install the 1043/5x0A series fire alarm control panels.
In this document there are only present some essential indications about product.
For further and detailed information, refer to manuals concerning 1043/5x0A control panels.
SAFETY REQUIREMENTS
WARNINGS
Read the notes in this manual carefully. This manual contains important information on safe installation, use and maintenance.
•
This equipment must only be used for the use for which it was expressly designed, i.e. for fire alarm control panel systems.
•
This device was designed to be compliant with the standards in force. All other use is improper use. The manufacturer cannot be
held responsible for damage deriving from improper, incorrect or unreasonable use.
•
The system must be built in compliance with the regulations in force. All devices in the system must be exclusively used for the
purpose for which they were designed.
•
Check that the device is intact after removing it from the packaging.
•
Keep the packaging (plastic bags, polystyrene, etc.) away from children. Packaging is potentially dangerous.
•
Make sure that the plate data corresponds to the power specifications before connecting the device to the mains.
•
This device shall be fitted by the installer inside an electric cabinet which might include also other devices, therefore it shall be
suitably identified.
•
During installation of the control panel, be very careful not to accidentally damage the
•
Keep the ventilation or cooling openings and slots free.
•
Disconnect the device from the mains before cleaning or maintenance. Do not use spray products to clean the device.
•
Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the device. Do not tamper with the
device.
•
Exclusively contact a service centre authorised by the manufacturer for repairs.
•
Do not install the device in environments exposed to dripping or splashing.
•
Do not install the control panel near heat sources (radiators, convectors, heating plants, etc.)
•
Do not use power extension wires.
•
Have the device checked and repaired by qualified personnel in the case of infiltration of fluid or objects inside the device.
•
Exclusively use the spare parts supplied by the manufacturer for repairs.
•
Installers must make sure that user's information is applied to the connected devices.
•
Disrespect of these precautions can effect safety of the device.
•
Keep this manual with the device at all times.
DS1043-271A
10
control and command board.
LBT21120