The Genius 2D has two (2) automatic modes, and will begin charging when both the battery and power are connected. Do not operate the charger until you confirm

the Genius 2D charger is compatible with your battery type and voltage. Below is a brief description:

Mode

Explanation

The charger is connected to AC power but no battery is detected, and the charger is not charging. Energy Save is activated during this mode,

drawing microscopic power from the electrical outlet.

Standby

No Power

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free, Calcium batteries and AGM.

12V NORM

14.5V | 2000mA | Up To 40Ah Batteries | Maintain all sizes

On-Board Mounting.

Mount the charger near the battery, ensuring the cables and charger are secure and away from any moving parts (eg. fan blades, belts, pulleys). Secure the

provided mounting bracket to the vehicle's chassis using the two included self-tapping screws. For best results, mark the position using the bracket, and pre-drill

two small pilot holes. Once the bracket is secured, use the velcro strap to secure the Genius 2D in place.

Connecting to the Battery.

Do not connect the AC power plug until all other connections are made. Identify the correct polarity of the battery terminals on the battery. The positive battery terminal

is typically marked by these letters or symbol (POS, P, +). The negative battery terminal is typically marked by these letters or symbol (NEG, N, -). Do not make any

connections to the carburetor, fuel lines, or thin, sheet metal parts.

FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE. WARNING: A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO

REDUCE THE RISK OF A SPARK NEAR THE BATTERY:

1.) Position AC and DC cords to reduce risk of damage by hood, door, or moving engine part.

2.) Stay clear of fan blades, belts, pulleys, and other parts that can cause injury to persons.