TROUBLESHOOTING
PROBLEM
The oven is not working.
The display shows the letter "F" followed
by a number or letter.
The oven does not heat up.
The light switches off.
The door will not close properly.
The home power goes off.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
•
Visiting our website
•
Using QR Code
•
Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification
plate.
12
POSSIBLE CAUSE
Power cut.
Disconnection from the mains.
Oven failure.
When "DEMO" is "On" all
commands are active and menus
available but the oven doesn't
heat up.
DEMO appears on display every 60
seconds.
"ECO" mode is "On".
The safety catches are in the
wrong position.
Power setting wrong.
docs . whirlpool . eu
contact our After-sales Service
SOLUTION
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Turn off the oven and restart it to see if the problem
persists.
Try to perform the "FACTORY RESET" from, selectable from
"SETTINGS".
Contact you nearest Client After-sales Service Centre and
state the number following the letter "F".
Access "DEMO" from "SETTINGS" and select "Off".
Access "ECO" from "SETTINGS" and select "Off".
Make sure that the safety catches are in the correct position
by following the instructions for removing and refitting the
door in the "Cleaning and Maintenance" section.
Verify if your domestic network has at least a rating of more
than 3 kW. If no, decrease the power to 13 Ampere. Access
"POWER" from "SETTINGS" and select "LOW".
(See phone number in the warranty booklet). When
XXXXXXXXXX
Model: xxxXXXXxx
XXXXXX XXXXXX
XXXXX XXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXX X X X X X XXX
XX
XXXX X X X
XXXXXX
400011401380