EINHELL PRESSITO 18/25 Hybrid Instructions D'origine page 18

Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
•
Damage to hearing if no suitable ear protec-
tion is used.
Danger!
The electric power tool generates an electro-
magnetic fi eld during operation. Under certain
circumstances this fi eld may actively or passively
impede medical implants. To reduce the risk of
serious or fatal injuries, we recommend persons
with medical implants to consult their doctor and
the manufacturer of the medical implant prior to
using the equipment.
5. Before using the equipment
Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to the supply voltage (if operating
from the mains power supply).
Before you connect the equipment to the power
supply make sure that the data on the rating pla-
te are identical to the data for the rechargeable
battery (if using a rechargeable battery for ope-
ration).
•
Check the equipment for damage which may
have occurred in transit. Report any damage
immediately to the transport company which
was used to deliver the compressor.
•
Make sure that the intake air is dry and dust-
free.
•
Do not install the compressor in a damp or
wet room.
•
The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5 °C to 40 °C). There must
be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
•
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with spray-
ed water.
•
Operate the equipment only on a firm, level
surface.
Anl_PRESSITO_18_25_Hybrid_SPK13.indb 18 Anl_PRESSITO_18_25_Hybrid_SPK13.indb 18
GB
Warning! When using the equipment to infl ate
objects, check the information and safety instruc-
tions provided by the manufacturer.
5.1 Charging the LI battery pack (Fig. 3, 5)
1. Remove the battery pack (6) from the handle,
pressing the pushlock button (a) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(d) into the socket outlet. The green LED will
then begin to fl ash.
3. Push the battery pack (6) onto the battery
charger (d).
In section 11 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit.
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.2 Battery capacity indicator (Fig. 3)
Press the button for the battery capacity indicator
(b). The battery capacity indicator (c) will indicate
the charge status of the battery by means of 3
LEDs.
- 18 -
15.12.2022 15:35:27 15.12.2022 15:35:27