AEG IEB64030XB Notice D'utilisation page 54

Problem
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
9. TECHNICAL DATA
9.1 Rating plate
Model IEB64030XB
Typ 61 B4B 01 AA
Induction 7.35 kW
Ser.Nr. .................
AEG
9.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Left front 2300
Left rear 2300
Right front 2300
Right rear 2300
The power of the cooking zones can be
different in some small range from the data in
54 ENGLISH
Possible cause
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 597 289 00
220 - 240 V 50 - 60 Hz
Made in: Germany
7.35 kW
PowerBoost [W]
3200
3200
3200
3200
the table. It changes with the material and
dimensions of the cookware.
Remedy
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 125 - 210
10 125 - 210
10 125 - 210
10 125 - 210
comes