Scheppach DG150GP Traduction Des Instructions D'origine page 28

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Engine does not run.
The engine starts
slowly and does not
reach the operating
speed.
Engine producing
excessive noise.
Engine does not reach
full power.
Motor overheats easily.
28 | GB
Possible cause
Engine, cable or
connector defective, fuses
burnt.
Voltage too low, coils
damaged, capacitor burnt.
Coils damaged, motor
defective.
Circuits in the network are
overloaded (lamps, other
engines, etc.)
Overloading of the engine,
insufficient cooling of the
engine.
www.scheppach.com
Remedy
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the same
circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.