SELF CLEAN OPERATION
(For High end models only)
SELF CLEAN operation will reduce
the growth of mold fungus with
Plasmacluster ions and dry inside
of the unit. Utilize the operation at
seasonal change over terms or every 4
months.
1
Press the SELF CLEAN button when
the unit is not operating.
• The remote control will display "
• The blue PLASMACLUSTER lamp (
will light up.
• The unit will stop operation after 90 minutes.
TO CANCEL
Press the SELF CLEAN button again.
• The blue PLASMACLUSTER lamp (
will turn off.
INVERTER_OM A881_EN.indd EN-11
INVERTER_OM A881_EN.indd EN-11
".
)
)
SENSOR
1
EN-11
MAINTENANCE
Be sure to disconnect the power cord from
the wall outlet or turn off the circuit breaker
before performing any maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the filters.
Lift the open panel.
Pull the air filters down to remove them.
3
Clean the filters.
• Use a vacuum cleaner to remove dust. If the
filters are dirty, wash them with warm water
and a mild detergent. Dry filters in the shade
before reinstalling.
4
Reinstall the filters and close the
open panel.
CLEANING THE UNIT AND THE RE-
MOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It
can cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders
or strong solvents.
MAINTENANCE AFTER AIR CONDI-
TIONER SEASON
1
Dry the inside of the indoor unit thor-
oughly by taking the following steps.
(High end models)
Run the unit in the SELF CLEAN operation mode.
(Standard models)
Run the unit in the COOL mode with temperature
setting of 30°C.
2
Stop the operation and unplug the
unit.
• Turn off the circuit breaker, if you have one
exclusively for the air conditioner.
3
Clean the filters, then reinstall
them.
MAINTENANCE BEFORE AIR CONDI-
TIONER SEASON
1
Make sure that the air filters are not
dirty.
2
Make sure that nothing obstructs
the air inlet or outlet.
11/8/2559 BE 5:14 PM
11/8/2559 BE 5:14 PM