6 - A
IV - Modifying the layout of your cabinet
To change the position of a storage shelf, you must first of all unload the shelf, then remove the
shelf supports taking care to reinstall them as shown opposite:
To change the position of a sliding shelf, you must first of all completely unload it.Then lift out the sliding tray by sliding it forwards whilst at the same time
lifting it from the front. Find the runner guides on the left and right and remove.Then reinstall them in the new position as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding drawer as shown opposite:
7 - C
1- Connecting up your wine cabinet
Check that your socket has a power supply (presence of fuses and ampmerage,
and that there is an operational 30 mA circtuit breaker*)
* Not applied to certain countries.
Having waited for 48 hours, switch on your wine cabinet at the main power
suply
II- Switching on the cabinet
Press on the internal
and standby button and then release. A start-up message flashes for 5 seconds before the cabinet's temperature is displayed.
At the time of switching on, if the set temperature is less than the ambient temperature, the blue cold circuit indicator will light up.
If the set temperature is higher than the ambient temperature, the red hot circuit indicator will light up.
To put your cabinet in stanby, press on the button
RRANGEMENT AND STORAGE
S S e e t t t t i i n n g g u u p p t t h h e e r r e e a a r r p p a a r r t t
o o f f t t h h e e g g u u i i d d e e
Sliding shelf
Guide
OMMISSIONING YOUR WINE CABINET
for 5 seconds.
Shelf
support
S S e e t t t t i i n n g g u u p p t t h h e e f f r r o o n n t t p p a a r r t t
o o f f t t h h e e g g u u i i d d e e
Guide
Wall
Wall
Wall
Guide
1 1 3 3
E E N N