Publicité
Les langues disponibles
Les langues disponibles
5 - I
NSTALLING YOUR WINE CABINET
b - Fitting the door handle (solid door)
The door handle is included in the box of accessories that you will find
inside the wine cabinet.
In order to fit it (example for a right hand door):
• Open the door (1)
• Place the handle (2) vertically (with the grip section downwards), see
Fig.1
• Use the plastic nut (4), to screw on the pin (3) (on the hinge side (14) of
the door) without fully tightening see Fig.1
Fig. 1
• Lift the handle (2) to its final horizontal position see Fig.2
• By hand, use the plastic nut (4) to screw on the lock (5), see Fig.2
Fig. 2
• Place the lock so that the key hole is vertical, and always directed
downwards, see Fig.3
Fig. 3
• Hand tighten the two plastic nuts (4) to the maximum, then finish
tightening using a 28mm spanner (a) (Maximum 1/2 turn of the spanner)
provided in the accessory box
• Attach the locking bar (6), on the end of the lock (5), with the screw (7)
using the Torx "T20" (b) tool provided in the accessory box, see Fig. 4 and 5.
Fig. 4
* !!! Take care to ensure the direction in which the locking bar(6) rotates,
this should always be upwards (irrespective of whether the door is fitted
on the left or right)
!!! Take note, for security reasons, the key has a "double movement": you
must at the same time both push it in and turn it while keeping it
pressed, see Fig.6
Fig. 6
• Stick on the self-adhesive "EuroCave" logo (8), see Fig.7
Remember to peel off the protective film covering the logo.
Fig. 7
Fig. 5
9 9
E E N N
Publicité
