Publicité
Les langues disponibles
Les langues disponibles
5 - I
c - Alternative hanging of a solid door
The solid wine cabinet door can be hinged either left or right.
You can change which way it opens.
To do this, proceed as follows (example for changing a right hand door to
a left hand door):
• Close the door
• Remove the grommets (9-10-12) gently using a fine blade, see Fig. 8
• Loosen the three screws (13) using the Torx "T25" tool, see Fig.8.
• Remove the upper hinge (14), see Fig. 8.
Fig. 8
• Remove the plastic pivot (15) and the grommet (9) and swap them over,
see Fig. 9
Fig. 9
• Lift the door from the lower hinge by opening the door slightly and then
lifting it.
• Remove the grommet (11) gently using a fine blade, see Fig. 10
• Unscrew the door pivot guide (16) with the washer (17), then tighten it
onto the same part on the opposite side, see Fig.10 (a 10mm spanner can
be used)
• Relocate the grommet (11), on the opposite side see Fig.10
Fig. 10
1 1 0 0
NSTALLING YOUR WINE CABINET
• Loosen the four screws (18), see Fig. 11.
• Locate the foot (19) on the other side of the housing using the screws
(18) see Fig.11
Fig. 11
• Replace the door (1) on its pivot guide (16), not forgetting the washer
(17), see Fig.12
Fig. 12
• Relocate the hinge (14), using the screws (13) in such a way so that the
door is parallel with the case, see Fig.13
• Check (by closing the door) that the seal adheres well to the housing and
is leak proof
• Replace the grommets (10) and (12), see Fig.13
Fig. 13
• Change the handle opening direction (see chapter on handle assembly).
• Remove the logo by pushing on it (3) (access behind handle).
• Use the second logo provided in the accessory box.
• Replace the logo the right way up.
Publicité
