Control Lock Function; Degaussing The Screen - Sony Trinitron GDM-W900 Mode D'emploi

Control Lock
Function
The control lock function disables all the buttons on the
front panel except the u (power) and OPTION buttons and
the INPUT switch.
1
Press the OPTION button.
The "OPTION" OSD appears.
OPTION
2
Press the ¨./> button to select "LOCK."
3
Press the >?// button to select "LOCK."
The "OPTION" OSD automatically disappears after about
30 seconds. To turn off the OSD, press the OPTION button
again.
Once you select "LOCK," you cannot select other item on
the "OPTION" OSD using the ¨ ./> button.
If you press any button other than the u (power) and
OPTION buttons and the INPUT switch, the
appears on the screen.
To cancel the control lock
Press the > ?// button to select "UNLOCK."
Note
Use the control lock function only when necessary.
16
OPT I ON
L ANGUAGE JPN ENG FRA
DEU ESP I TA
OSD POS I T I ON : R I GHT BOTTOM
OSD MENU NORMAL EXPERT
LOCK UNLOCK LOCK
I NPUT : BNC 84.4kHz/ 72Hz
SELECT SET
mark
Degaussing the
Screen
The screen of the monitor is automatically degaussed when
the power is turned on (page 3).
You can degauss manually.
1
Press the SCREEN button.
The "SCREEN" OSD appears.
0 8
SCREEN
2
Press the ¨ ./> button to select "DEGAUSS."
3
Press the > / button.
The screen is degaussed for about five seconds.
SCREEN
H CONVERGENCE 8 5
V CONVERGENCE 7 2
CANCEL MO I RE OFF ON
MO I RE ADJ
LAND I NG AD JUST
DEGAUSS
ON
SELECT SET / ADJUST
0