Sony Trinitron GDM-W900 Mode D'emploi page 32

Adjustments (Expert mode)
Adjusting the picture
centering and size
The adjustment data becomes the individual setting for each
input signal received.
1
Press the SIZE button or the CENT button.
The "CENTER/SIZE" OSD appears.
CENTER / S I ZE
H CENTER
V CENTER
H S I ZE
V S I ZE
SELECT ADJUST
2
Press the ¨./> button to select and the > ?//
button to adjust the parameter.
H CENTER:
Adjusts the picture position in horizontal direction.
V CENTER:
Adjusts the picture position in vertical direction.
H SIZE:
Adjusts the picture size in horizontal direction.
V SIZE:
Adjusts the picture size in vertical direction.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the SIZE or CENT button again.
To reset, press the RESET button while the OSD is on. The
selected parameter is reset.
Adjusting the picture
rotation and the pincushion
The adjustment data becomes the individual setting for each
input signal received.
1
Press the GEOM button.
The "GEOMETRY" OSD appears.
GEOMETRY
H P I NCUSH I ON
H P I N BAL
H KEYSTONE
H KEY BAL
ROTAT I ON
S P I NCUSH I ON
S P I N BAL
C BOW
FL ARE TOP
F L ARE BOT
V L I NEAR I TY
V L I N BAL
SELECT ADJUST
14
EXPERT
1 0
1 0
2 3
2 3
EXPERT
10
33
100
75
50
42
93
93
0
75
0
75
2
Press the ¨ ./> button to select and the > ?//
button to adjust the parameter.
H PINCUSHION/
Corrects the picture distortion of the picture edges.
H KEYSTONE:
Corrects the difference of picture size at the top and
bottom.
H KEY BAL:
Corrects the imbalance of picture position at the top and
bottom.
ROTATION:
Corrects the picture rotation.
S PINCUSHION/ S PIN BAL/
Corrects the wavy distortion of the picture edges.
FLARE TOP/ FLARE BOT:
Corrects the flare distortion of the picture at the top and
bottom.
V LINEARITY/ V LIN BAL:
Corrects the vertical linearity and the vertical linearity
balance.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the GEOM button again.
To reset, press the RESET button while the OSD is on. The
selected parameter is reset.
Adjusting the screen
1
Press the SCREEN button.
The "SCREEN" OSD appears.
SCREEN
H CONVERGENCE
V CONVERGENCE
V CONV TOP
V CONV BOT
H FOCUS
CANCEL MO I RE OFF
MO I RE ADJ
LAND I NG
AD JUST
DEGAUSS ON
SELECT SET / ADJUST
2
Press the ¨./> button to select and the >?//
button to adjust the parameter.
H CONVERGENCE/V CONVERGENCE:
Adjusts the horizontal convergence and the vertical
convergence.
The adjustment data becomes the common setting for all
input signals received.
V CONV TOP/V CONV BOT:
Adjusts the vertical convergence at the top and bottom
of the screen.
The adjustment data becomes the common setting for all
input signals received.
H FOCUS:
Adjusts the horizontal focusing.
The adjustment data becomes the common setting for all
input signals received.
H PIN BAL:
C BOW:
EXPERT
8 5
7 2
1 0 0
7 5
50
ON
0