Adjusting The Color - Sony Trinitron GDM-W900 Mode D'emploi

CANCEL MOIRE:
Cancels the moire when "ON" is selected.
The adjustment data becomes the individual setting for
each input signal received.
MOIRE ADJ:
Reduces fuzziress of the picture caused by canceling
moire.
Adjust beginning from 0 until the moire is minimum.
The adjustment data becomes the individual setting for
each input signal received.
LANDING:
See "Landing" on page 11.
The adjustment data becomes the common setting for all
input signals received.
DEGAUSS:
See "Degaussing the screen" on page 16.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the SCREEN button again.
To reset, press the RESET button while the OSD is on. The
selected parameter is reset.

Adjusting the color

The adjustment data becomes the common setting for all
input signals received.
1
Press the COLOR button.
The "COLOR" OSD appears.
COLOR
COLOR TEMPERATURE
5 0 0 0K 65 0 0K 9 3 0 0K
VAR I ABLE
R B I AS
G B I AS
B B I AS
R GA I N
G GA I N
B GA I N
SELECT SET / ADJUST
2
Press the >?// button to select the color
temperature to adjust, 5000, 6500 or 9300.
3
Press the ¨./> button to select and the >?//
button to adjust the parameter.
VARIABLE:
Adjusts the color selected in step 2 to the desired color
temperature. The figure of the selected color
temperature changes.
R BIAS/G BIAS/B BIAS:
Adjusts the black level of each signal. "++" appears at
the right shoulder of the adjusted color temperature.
R GAIN/G GAIN/B GAIN:
Adjusts the white level of each signal. "++" appears at
the right shoulder of the adjusted color temperature.
EXPERT
1 0 0
50
50
50
50
50
50
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the COLOR button again.
To reset all parameters of a particular color
temperature
Select the color temperature in step 2, and then press the
RESET button. All parameters of the color temperature are
reset and "++" at the right shoulder disappears.
To reset a particular parameter of a particular color
temperature
Select the parameter in step 3, and then press the RESET
button. Only the selected parameter of the color
temperature is reset.
Resetting to the factory-
preset levels
Reset in the same way as described in "Resetting to the
factory-preset levels" on page 12.
EN
F
D
ES
I
J
15