JB Systems PARTY BAR Mode D'emploi page 11

ENGLISH
 Use the [UP/DOWN] buttons to select the desired DMX-mode. (3CH, 5CH, 6CH, 9CH or 27CH)
 Press the [ENTER] button to confirm your choice.
 Now you can use the [UP/DOWN] buttons to set the DMX address. [dxxx]
 Press the [ENTER] button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of the
light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the end of
the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
3 CHANNEL DMX-CONFIGURATION:
DMX DMX-
Channel value
000-009
010-031
032-065
066-095
1 096-127
128-159
160-191
192-223
224-255
000-009
010-019
020-029
030-039
040-049
2 050-059
060-069
070-079
080-089
090-099
100-109
JB SYSTEMS®
function
Blackout
Auto Par
Auto Laser
Auto Flash led
Auto Mix
Sound Par
Sound Laser
Sound Flash Led
Sound Mix
Channel 1 = Auto Par mode (DMX value between 010 and 031)
AP01
AP02
AP03
AP04
AP05
AP06
AP07
AP08
AP09
AP10
AP11
Automatic show of the RGB projectors & derby only
Automatic show of the laser effect only
Automatic show of the white flash led's only
Automatic show of all the effects
Sound controlled show of the RGB projectors & derby only
Sound controlled show of the laser effect only
Sound controlled show of the white flash led's only
Sound controlled show of all the effects
Different automatic RGB Projector & Derby modes
9/87
USER MANUAL
remarks
PARTY BAR