Teac V-8030S Manuel Du Propriétaire page 10

Timer-Controlled Playback
1, Connect the power cords of all compo-
nents as shown in the diagram.
. Set the audio timer (optional) to ON.
. Set the stereo amplifier to TAPE.
. Load a pre-recorded tape into the deck,
then set the Dolby NR as required.
. Set the audio timer for the required
start (power on) and stop (power off)
times. After these settings, the power to
all components will be switched off.
6. Set the timer switch of this deck to
play.
PON
a
*When the preset start time is reached,
playback will start in a few seconds.
*Be sure to set the timer switch to off
upon completion of timer-controlled re-
cording/playback,
Timer Connection [umn
&
Audio timer r
= =
Tuner To AC outlet of
Amplifier
'
alee
5 the timer
= ||
fo-00Q-000|
To amplifier's
AC outlet
V-8030S/V-6030S
vo —-=
Remote-Controlled Operation
The provided Remote Control Unit allows
the unit to be operated from a distance.
When operating the remote control unit,
point it towards the remote sensor on the
front panel of the unit.
© Even if the remote control unit is
operated within the effective range,
remote contro! operation may be
impossible if there are any obstacles
between the deck and the remote
control.
If the remote control unit is operated
near other appliances which generate
infrared rays, or if other remote control
devices using infrared rays are used
near the deck, it may operate
incorrectly. In the reverse way, the
other appliances may operate
incorrectly.
—10-
Battery Installation (Fig. 4)
1. Remove the battery compartment
cover.
2. Insert two "AA" (R6, SUM-3) dry
batteries.
Make sure that the batteries are
inserted with their positive ® and
negative © poles positioned correctly.
3. Close the cover until it clicks.
Battery Replacement
If you notice that the distance between
the remote control unit and the deck for
correct operation becomes shorter, it
indicates that the batteries are exhaust-
ed. In this case replace the batteries with
new ones.
Precautions concerning batteries
© Be sure to insert the batteries with
correct positive @ and negative ©
polarities.
© Use batteries of the same type. Never
use different types of batteries
together.
@ Rechargeable and non-rechargeable
batteries can be used. Refer to the
precautions on their labels.
© When the remote control unit is not to
be used for a long time (more than a
month), remove the batteries from the
remote control unit to prevent them
from leaking. If they leak, wipe away
the liquid inside the battery
compartment and replace the batteries
with new ones.
© Do not heat or disassemble batteries
and never dispose of old batteries by
throwing them in a fire.