Publicité
Les langues disponibles
Les langues disponibles
GB
Problem
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
18. Technical Data
Max. viscosity
Power source
Power consumption
Atomizing output:
Max. flow rate:
Protection Class:
Sound pressure level*
Sound pressure output*
Oscillation level*
Weight
* Measured in accordance with 50580:2014
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can differ from the specified value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched off, and, when it is switched on but running without any load).
26
Cause
•
Distance to the object too large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
Technical Data
100 DIN-s
230 V
, 50 Hz
~
300 W
70 W
140 ml/min
I
75 dB (A); Uncertainty K = 4 dB
86 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
1.2 kg
Remedy
➞ Reduce distance
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean the diaphragm
➞ Replace the diaphragm
W 150
Publicité
