Jotul F 262 Manuel D'installation & D'utilisation page 6

ENGLISH
4.4 Fitting the flue pipe with the rear
outlet
The product is supplied from the factory with the smoke outlet
fitted for the top outlet.
NB! Proceed as follows for installation with a rear outlet:
Fig. 4
When installing with soapstone side panels, the rear plate (Fig.
4 B) has to be prepared before the product is placed on its final
position.
Knock out the removable cover plate (Fig. 4 A) in the rear
1.
plate (Fig. 4 B).
Hang the rear plate gently on the flue pipe (Fig. 4 C).
2.
Place the product in the correct position. (See Fig. 1a).
3.
Fig. 5
B
A
Lift the baffle (Fig. 5 A) up carefully.
1.
2. Remove one of the side burn plates by lifting them up a little
and then out. (Be aware if using tools, that vermiculite plates
may be damaged by rough handling).
3. Remove the baffle.
4. Remove the other side burn plate.
Remove the exhaust deflectors (Fig. 5 B).
5.
6
A
C
B
Fig. 6
B
Unscrew the screws (Fig. 6 A) and remove the smoke outlet
1.
(Fig. 6 B) from the inside of the burn chamber.
Fig. 7
Unscrew the screws (Fig. 7 C) and remove the cover (Fig. 7 B)
1.
from the rear outlet from the inside of the burn chamber.
Fig 8
A
Knock out the removable covers (Fig. 8 A).
1.
Attach the smoke outlet (Fig. 7 A) on the inside of the burn
2.
chamber where the cover was.
3. Install the cover (Fig. 7 B) where the smoke outlet was.
4. Refit the exhaust deflectors (Fig. 5 B) and the baffle plate
(Fig. 5 A).
A
B C
A