Russell Hobbs 18258S Manuel page 7

SWITCHING ON

Position the kettle on the power base.

Plug the kettle into a mains supply socket.

To start boiling the kettle, press the on/off switch down to "1" (on) position.

The power indicator light will illuminate and the kettle will start to boil.

Never open the lid during boiling.

Do not operate this kettle without the filter fitted.
Please beware of escaping steam from the lid of the kettle when in use.
USAGE STEPS

Put the power base on a flat table.

Push the button lightly to open the lid and fill in a proper amount of water. Close
the lid and put the kettle on the power base.

Connect the power cord into a suitable power outlet.

Move the switch to the "ON" position. The indicating light will go on indicating that
the heating and boiling process has begun.

Once the water has boiled, the switch will move to the "OFF" position. Disconnect
the kettle from the power supply and the indicating light will go off.

During boiling, you can move the switch to the "OFF" mark with your hand to cut
the power supply.

Pour out the water only after you have lifted the kettle from the base.

The kettle can be put on the power base but with power supply disconnected
after using.
BOIL DRY HEATING PROTECTION

If you have forgotten to add water or the water inside is below the minimum
accepted level, the metal sheet for dry heating protection of the temperature
controller will disconnect automatically when the kettle is switched on in order to
protect the kettle from being damaged by dry heating.

If the above situation happens, please turn off the power supply, unplug the kettle
and wait 10 minutes for it to cool down. Once this is done, the temperature
controller connects and the kettle will operate normally again.
7