Installing A Latch Without Call Memory; Installing The Name Tag - SOMFY VSYSTEMPRO Manuel D'installation

7.2 Wiring a call memory latch

7.3 Installing a latch without call memory

If using a latch without call memory, a maximum external power supply of 24 V should
be used. This latch shall be actuated by the external module relay in "dry contact" mode.
It is then necessary to correclty set the activation time of this relay, see 5.1 Switch
No. 28, page 9.
7.4 Wiring a latch without call memory
[1]. Press and push down on the right-hand side of the name tag protector.
[2]. Using a screwdriver, raise the protector in order
to release the name tag.
[3]. Write your name on the tag with a permanent
marker, put the tag back in position
[4]. Insert the protector from the le and clip it on by
gently pushing on the right.

8 INSTALLING THE NAME TAG

Copyright © 2016 Somfy SAS. All rights
24 V max.
AC / DC
reserved.
EN
12