Other Settings; Adjusting The Camera Angle - SOMFY VSYSTEMPRO Manuel D'installation

Note: This relay can be activated:
- by pressing the button on the monitor.
- by pressing a push-button connected to the PTE + GND terminals on the external module
terminal (option, see 6 - "Press to exit" button, page 11).
Switch 6
This switch enables the maximum conversation time with the monitor to be defined.
Position of the switch
ON
1 2 3 4 5
Note: switches 7 and 8 are not used.

5.2 Other settings

Adjusting the volume
Carry out a communications test with the monitor and adjust in the following order, using
a flat-head screwdriver:
Loud
speaker
volume
Microphone
gain
Balance
Balance

5.3 Adjusting the camera angle

Note: this operation is not required on the Premium model.
[1]. Open the external module housing frame.
[2]. Unscrew the camera locking screw.
[3]. Tilt the camera.
[4]. Tighten the locking screw.
[5]. Refit the external module frame taking care not to trap the
microphone wire.
[6]. Check the tilt angle of the camera, testing with a monitor.
[7]. Close the external module frame.
Time
1 min
6 7 8
With someone talking normally in front of the
monitor, adjust the volume of the speaker by turning
the corresponding rotary switch.
Talk in front of the microphone and adjust the
microphone gain so that the voice is audible for the
person in front of the monitor.
Adjust the rotating switch so that there is no echo in
the external module speaker when someone speakes
into the microphone.
Copyright © 2016 Somfy SAS. All rights
Position of the switch
ON
1 2 3 4 5 6 7 8
reserved.
EN
Time
2 min
10