Important Safety Information; Fire Hazard; Explosion Hazard - Hatco GLOMAX GM5AH Série Instructions Originales

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Units require a hardwired connection
to on-site electrical system. Connection
must be properly grounded and of correct
voltage, size, and configuration for
electrical specifications of unit. Contact
a qualified electrician to determine and
install proper electrical connection.
• Unit must be installed by a qualified
electrician. Installation must conform
to all local electrical codes. Installation
by unqualified personnel will void unit
warranty and may lead to electric shock
or burn, as well as damage to unit and/or
its surroundings.
• Control box must be mounted in a
vertical surface. Mounting control box
in a horizontal surface may result in the
collection of liquids and lead to electric
shock.
• Turn OFF power switch, turn off power
at circuit breaker, and allow unit to
cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if
unit has been submerged or saturated
with water.
• This unit is not "jet-proof" construction.
Do not use jet-clean spray to clean this
unit.
• Do not steam clean or use excessive
water on unit.
• Use only Genuine Hatco Replacement
Parts when service is required. Failure
to use Genuine Hatco Replacement
Parts will void all warranties and may
subject operators of the equipment to
hazardous electrical voltage, resulting
in electrical shock or burn. Genuine
Hatco Replacement Parts are specified
to operate safely in the environments in
which they are used. Some after-market
or generic replacement parts do not have
the characteristics that will allow them to
operate safely in Hatco equipment.
Form No. GM5AHCEM-0619

IMPORTANT SAFETY INFORMATION

FIRE HAZARD:

• Do not install units above or around
combustible surfaces. Discoloration
or combustion could occur. Units
must be installed in non-combustible
surroundings only.
• Do not install strip heaters less than
254 mm (10") above non-combustible
surfaces. If safe distances are not
maintained, discoloration or combustion
could occur.
EXPLOSION HAZARD: Do not store or use
gasoline or other flammable vapors or
liquids in the vicinity of this or any other
appliance.
Make sure all operators have been instructed
on the safe and proper use of the unit.
This unit is not intended for use by children
or persons with reduced physical, sensory,
or mental capabilities. Ensure proper
supervision of children and keep them away
from the unit.
Use only Hatco-approved LED light
assemblies that are designed specifically
for food holding areas. Using LED light
assemblies not designed for food holding
areas could result in personal injury and/or
food contamination.
Make sure food product has been heated
to the proper food-safe temperature before
placing in unit. Failure to heat food product
properly may result in serious health risks.
This unit is for holding pre-heated food
product only.
This unit has no "user-serviceable" parts.
If service is required on this unit, contact
an Authorized
contact the Hatco Service Department at
+1-414-671-6350.
3
WARNING
Hatco Service Agent or