Recycling Instructions - simatec simalube 30 Mode D'emploi

EN
The values relate to laboratory conditions, SL01 with no counterpressure. At low tempe-
ratures in particular, the values may vary between one grease type and another. The
dispensers must be replaced once the dispensing time set has expired, even if they are
not completely empty.
The grease quantity dispensed
per day is influenced by:
Start-up time:
The lubricator requires a certain start-up time until the lubricant is first dispensed. The
start-up time varies in line with the volume dispensed, dispenser size and operating
temperature selected. At 20 °C ambient temperature and a dispensing time setting of 12
months, the dispenser outputs the lubricant within one week. The start-up time doubles at
low temperatures (–20 °C) or with small dispensers (30 ml).
You can reduce the start-up time in such a case by setting a dispensing time on the
lubricator of one month for one to two days and then changing to the desired dispens ing
time.
Free online programs at www.simatec.com:
Calculation Pro
Lubechart
Notes:
In order for the unit to function reliably, it is important to have clear, filled grease lines.
It must be ensured that the grease lines are not blocked. Consequently, the grease lines
should always be cleared with a grease gun before starting.
The simalube can be re-adjusted or switched off during operation. The values on the gas
generator relate to laboratory conditions (see page 10). Depending on the temperature
and setting, it may take several hours (or several days in the case of long-term settings)
until the lubricant is first dispensed. The user must check the operation of the simalube
regularly.
Grease lines should be no longer than 0.5 m. Recommended bore diameter: 6–8 mm.
Resistance in grease lines has to be minimized, narrow passages and right angles
should be avoided. Use a mounting support in the event of strong vibrations or high
accelerations (for accessories, see pages 33–39). Use the pressure booster (art.
230.1000) simalube IMPULSE with long lubrication lines or high back pressure.
The simalube may only be used to supply a single grease point. No branches may
be made. Once the lubricator is installed and activated, it must not be removed and
mounted onto another lubrication point.

Recycling Instructions

– counterpressure/resistance from
the grease lines
– ambient temperature
– viscosity of the grease
App suggests correct simalube size and setting
based upon entered operational data.
Input simalube locations and settings and receive
reminders when replacements are required.
1) Unscrew gas generator and dispose of
complete unit for battery recycling (see
above). Note: Do not detach lubricator
near an open flame.
2) Dispose of empty housing for plastic recyc-
ling. If the lubricator still contains lubricant
after use, please dispose of it in accord-
ance with local regulations.
12