Publicité
Les langues disponibles
Les langues disponibles
REAR CROSS
CHANNEL
ADJUSTMENT
Slide the dishwasher
into the cabinet opening, being careful to avoid damage to the floor or interference with water,
drain, and electrical lines. DO NOT remove the rear cross channel, unless there is an interference with the plumbing
lines. In most cases, any plumbing interference can be eliminated by raising one side of the rear cross channel. (See
Fig. 10 for details.)
Back of dlshwasher
Rear cross channel
I" alternate
pos~llon
SteD
SleD
Looser
lhls SC'YW _
Remove
lhls screw. _
Line up the lower cross
channel
hole with ihe
upper hole in frame
Fasten securely
Tighten
.screw at other end.
-
Step
1 ~ Remove
these screw'
cross channel
lglnal posltlon
the
s.
Fig. 10a
Unlatch
and open the door and remove the foam shipping
cushions
from uppelr corners
of the door. Check
to ensure that cabinet clearance
is equal on both sides of the dishwasher
and that cabinet
interference
does
not distort dishwasher
tank.
With the door still open, place a spirit/bubble
level against the front tank flange (Fig. 11) and level the dishwasher
front-to-back
and side-to-side
by adjusting
the leveling legs (Fig. 12) In or out as necessary.
Adjustable
bracket
in
shlpolng
posltlon
>
Fig. 11
If the dishwasher
is not properly leveled or if it is distorted by cabinet interference,
the door may not seal properly
and may leak. If necessary, the leveling leg may be further adjusted to correct any distortion
and align tank for
equal clearance
on both sides (Fig. 12).
-9-
Publicité
