Télécharger Imprimer la page

KitchenAid KUD-22 Serie Instructions D'installation page 13

Publicité

Les langues disponibles

Les langues disponibles

8
FRONT PANEL VARIATIONS
Vari-Front
Panel Pack -
All KitchenAid
dishwashers
are equipped
with reversible
front panels.
If you wish
to change
the colour of your dishwasher
panels,
consult
your Use and Care Guide for instructions
on how
to reverse these panels.
Custom Panels -
If custom wood or decorator
front panels are to be used, they should be
l/4"
(6 mm) thick.
Length and width dimensions
should
be the same as the Vari-Front
panel inserts.
If wood panels are less
than %I" (6 mm) thick, they must be shimmed
up to the required
114"
(6 mm) with appropriately
sized back
up board (corrugated
cardboard,
masonite,
etc.). If wood panels are thicker than
l/4
' (6 mm), the edges will
have to be trimmed down on all four sides as shown in Fig. 20. IMPORTANT:
The finish
applied
to custom
wood panels should
be applied
to the front,
back, and all edges,
and must be waterproof
since a certain
amount
of moist
air is discharged
from the machine.
l/4 " (6 mm)
THK. -
1 "
(25 mm)
1 W/,6'
(476 mm)
Fig. 20
Models 4KkJDA220T
and 4KUDA22ST
only.
'/4 " @ mm) 7r
THK.
have a 1"
17% 6"
(443 mm)
-
5/,6" (6 mm)
2 SIDES
I
1 "
(25 mm)
'\
Fig. 21
The use of custom panels may necessitate
adjustment of the door tension. The door should be counterbalanced
(i.e. doesn't fall open when unlatched
or pull itself closed from the open position).
If the door pulls Itself closed from the open (hortzontal)
posItIon, close the door and adjust the door springs
by moving the adjustable door spring brackets (Fig. 21) upward to alternate holes. Move brackets downward
if the door falls open too quickly.
If the custom panels are too heavy and the door still falls open when unlatched,
heavy duty door springs,
part number
4171002,
should
be ordered
from your KitchenAid
dealer.
13 -

Publicité

loading