Télécharger Imprimer la page

KitchenAid KUD-22 Serie Instructions D'installation page 6

Publicité

Les langues disponibles

Les langues disponibles

2
PREPARING THE LOCATION
Access holes in the cabmets, floor, or rear wall for the hot water supply line, drain line, and electrical supply must
be located within the shaded area in Fig. 3 in order to avoid Interference
with the dishwasher
frame or other
components.
HOT WATER SUPPLY
LINE
Fig. 3
PLUMBING
CONNECTIONS
MUST COMPLY WITH APPLICABLE
SANITARY, SAFETY, AND PLUMBING
CODES.
I
Water supply
should
be 120°F (49OC) minimum
at the dishwasher.
(Refer to Use & Care Guide.)
The hot water supply
line should
be 5%" (16 mm) OD copper tubing
or
l/2"
(13 mm) galvanized
pipe. The
dishwasher
fill valve has a l/z" (13 mm) NPT female connection.
Atter determining
where the water supply
line will enter the dishwasher
opening,
drill a 1" (25 mm) access
hole and run the line to the approximate
fill valve location
as shown
in Fig. 4.
4" (102 mm)
-
(Frbm floor)
6" (152 mm)
Fig. 4
For service convenience,
a shut-off valve (not supplied) should be installed in the supply line in a readily accessible
location
(such as beneath the sink) and a union (not supplied)
should be installed
in the supply line near the
dishwasher
fill valve.

Publicité

loading