Publicité
Les langues disponibles
Les langues disponibles
To maintain
dishwasher
position
and alignment,
locate the adjustable
brackets
at the upper tank corners as
shown on Fig. 13 and secure them to the countertop
with self-drilling
flat head wood screws (supplied).
Drill
a pilot hole to a %I" (19 mm) maximum
depth in the centre of the bracket mounting
hole using a l/e" (3 mm)
drill bit. DO NOT exceed
%" (19 mm) depth. NOTE: Make sure screw
heads
will not interfere
with the
top of the door. If these brackets are not compatible
with your countertop,
the dishwasher
may be anchored
to the floor, with a l/4" (6 mm) lag bolt (not supplied),
through
the hole in each side of the dishwasher
frame
as shown
in Fig. 12.
Adjustable
bracket
m mstallat~on posltlon
,
Flat head wood screw
Fig. 13
4
CONNECTING THE WATER SUPPLY LINE
The water supply line should be flushed to clear any foreign material BEFORE connecting
to dishwasher.
Make sure there are no sharp bends or kinks which might restrict ,Nater flow
To facilitate
connection
of the water line from the rear of the dishwasher
it is recommended
that a Ye" (9.5 mm)
NPT street elbow be connected
to the fill valve and a 90' compression
elbow (Ye" (9.5 mm) NPT one end)
be connected
to the street elbow. The supply line can then be connected
to the compression
elbow (see Fig. 14).
NOTE: If galvanized
pipe is used, substitute
a second 3/a" (9.5 mm) street elbow and l/2" (13 mm) NPT and
Ye" (9.5 mm) NPT reducing
adaptor
for the compression
elbow.
Turn on water supply and check for leaks
Compresslon
flu1
Compresslon
sleeve .,
%I* (16 mm) O.D. copper
water line
90" cc;mpresslon
elbow
-~
(VS (9.5 mm) NPT one end)
DIshwasher
fill valve
Fig. 14
Publicité
