Publicité
Les langues disponibles
Les langues disponibles
Installation of indoor unit
Step eight: bind up pipe
1. Bind up the connection pipe, power
cord and drain hose with the band.
indoor unit
2. Plan for bends in line set and ensure
that cable and drain have extra
length in those areas. Otherwise
route these seperate from liquid and
gas pipe.
Step nine: hang the indoor unit
1. Pass wrapped piping and drain/cable through hole in wall. (Ensure that drain is on
on the bottom.)
2. Hang the indoor unit on the wall-mounting frame.
3. Stuff the gap between pipes and wall hole with insulation.
4. Secure the wall pipe.
5. Check if the indoor unit is installed firmly and closed to the wall
indoor
wall pipe
Note:
● Do not bend the drain hose excessively in order to prevent blocking.
indoor and
outdoor power cord
gas
pipe
liquid pipe
band
drain hose
outdoor
sealing gum
connection pipe
indoor power cord
3. Bind them evenly.
4. The liquid pipe and gas pipe should
be bound separately at the end.
Note:
● The power cord and control wire
can't be crossed or winding.
● The drain hose should be bound
at the bottom.
lower hook of
wall-mounting frame
23
drain hose
band
upper hook
Publicité
