Publicité
Les langues disponibles
Les langues disponibles
Installation of indoor unit
2. Make the power connection wire go
through the cable-cross hole at the back
of indoor unit and then pull it out from
the front side.
3. Remove the wire clip; connect the power connection wire to the wiring terminal
with wire clip.
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
Notice before installation
1. How to install the over line pipe(According to the direction as show.)
wire pipe
2. Finish(According to the direction as show in right figure.
Note:
● All electrical connections must be completed by a qualified professional.
● If required by local code install circuit breaker inline. Must be 3-Pole.
Screw
Fixed nut
cable-cross
hole
power connection
wire
18,24K indoor unit:
N(1)
2
3
yellow-
blue
black
brown
green
Outdoor unit connection
22
Publicité
